Crafting | Making a woven wreath

sisal rope wrapped around metal wreath frame
This week’s project — a DIY woven wreath — has been on my to-do list for about a year and a half.

wreath base
That’s when I dragged this wire frame home from a garage sale. Actually when I dragged it home, it was green, but I forgot to take a “before” picture until after I had spray painted it tan. The reason I painted it? Because I was going to weave some rope around it, and I knew parts of the frame would end up exposed.

woven wreath
The weaving process was pretty straightforward: I went over one wire and under the next, then wrapped around the inside (and outside) wire to start over again.

woven wreath
When I reached the end of the rope, I tucked it into the back of the wreath and glued it down to keep it in place. Then I started with a new piece, keeping the same over-under pattern going.

woven wreath
Here’s what it looked like when I had the entire wreath wrapped.

sisal rope wreath
If you look closely, you can see the wire peeking out in some spots, but since it’s the same color as the sisal rope, it’s hardly noticeable.

Christmas bell ornaments
Next, I hung a few metal bells from twisted pieces of twine. (I applied a little Mod Podge along the length of the twine to set the twists in place and keep them from unwinding.)

rope wreath
Then I attached the bells and a few trimmings from the bottom of our Christmas tree to the back of the wreath.

sisal wrapped wreath
I also wired a couple of rusty jingle bells to the top of the evergreen branches …

sisal wreath
… and wrapped an old leather strap around the top of the wreath as a hanger.

sisal rope wreath
After Christmas, I figure I will throw out the branches and pack the bells away, but the wreath itself can stay hanging up year round.

sisal Christmas wreath

 

9 Replies to “Crafting | Making a woven wreath”

    1. Here’s the rope I used: https://www.menards.com/main/tools-hardware/material-handling/ropes-rope-handling/kingcord-1-4-x-100-twisted-sisal-rope/300161mn/p-1444439537082-c-12173.htm?tid=-1725350275890952733&ipos=5 (Hopefully the link works; if not, it’s 1/4-inch rope and it came in 100-ft. lengths. I think I used about half of the rope, so roughly 50 feet.)

      Someday I’ll write a follow-up post about my wreath. I get questions about it all the time. It apparently struck a cord with a lot of people. Thanks for reading! Good luck w/ your wreath!

      Lisa

      Like

    1. Sorry, no video. It’s pretty simple to make though. Just get a long length of rope and weave it over one wire and under the next, all the way around the wreath. And if you have to start with a new length of rope, knot it or glue it down on the back side of the wreath so it doesn’t show. Here’s the rope I used: https://www.menards.com/main/tools-hardware/material-handling/ropes-rope-handling/kingcord-1-4-x-100-twisted-sisal-rope/300161mn/p-1444439537082-c-12173.htm?tid=-1725350275890952733&ipos=5

      Like

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s